Posts Tagged ‘razor 98’
DUBAI // A maid cut off her 77-year-old sponsor’s penis with a straight razor because he had raped her, a court heard this morning.
JN, 26, from Bangladesh, sobbed in the Criminal Court of first Instance today and declined to enter a plea to the charge of causing permanent disability.
In records, she testified that on April 9, her sponsor, MM, raped her in her room after threatening to throw her out of the house if she did not obey his sexual demands. She said he raped her again the next day.
About 11am on April 11, while she was in her room, she said MM asked her to pleasure him.
“I noticed a shaving blade on the cupboard next to the bed,” JN told prosecutors.
She said she started pleasuring him and as he was distracted, she grabbed the blade and cut off his penis. She threw it in the rubbish bin, she said.
MM began screaming and JN ran to another room and hid, records show.
MM’s son KM, 19, told prosecutors that he woke up to his father’s screams. when he saw MM covered in blood, he called police.
“My father was sitting in a chair opposite my room bleeding severely,” KM said.
KM said he then saw JN trying to escape, so he stopped her. Police arrived soon afterward and MM was taken by ambulance to Rashid Hospital.
A medical report said that the organ was reattached, but that MM would suffer permanent disability.
“It was difficult to determine if the organ’s ability to function properly is still available, as the victim said he did not have sex for two years,” said the forensics doctor in prosecution records.
The report also said tests could not confirm whether JN was raped.
The case was adjourned until September 15 so a Bangladeshi translator could be provided.
He has a gotee so he usually uses a razor to shape that area…would getting him an electric razor be a waste?
I know he could use it on his neck, which would probally feel better than a cheap razor, but are there any that you can use around the gotee that won't mess it up?
Also are the electric shavers with a cleaner in them good?
Braun or norelco. Both have a 30 day return policy. they say it takes a couple of weeks for you to get used to the new razor. If you (he) still doesn't like it, you can send it back to the manufacturer for 100% refund. Just save the receipt.
I think electric razors are crap. Good non-electric ones work much better.
Better make sure he wants one. I don't go near them.
What is a straight razor?
A cut throat razor has a single straight blade that is attached to a handle by a hinge and that is stored by folding it edge-first into a slot in the handle of the razor.
This method of shaving with a cut throat razor or straight razor is the most traditional and argued by some shaving traditionalists as the only way to shave.
The straight-edge razor was also called the cut-throat razor because it was dangerous enough to cut a man’s throat. .
History As far back as the civilizations of Rome and Greece used iron blades with a long handle and developed the shape of the cut-throat’ razor which was the only practical razor until the 19th century. with improvements in steel manufacture came cut throat razor blades that were really sharp and capable of being re-sharpening.
Advances in razor technology changed shaving habits in the 20th century. in 1900, most men were either shaved by the local barber (your trusted confidante, wielding a cut throat razor), or periodically at home when required, rather than regularly. The barber’s better-off customers would have personal sets of seven cut throat razors, labeled ‘Sunday’ to ‘Saturday’. Today, nearly all men shave everyday in their own homes, using a wide variety of equipment.
Cut-throat razor must be used with extreme caution. Executive Shaving would be very pleased to give advice on using the cut-throat razor before purchase.
Straight Razor Material. In general, the blades of straight razors are made of steel, the more recent razors have blades made from stainless steel. The manufacturer’s markings are often found engraved or etched on the blades which may include the model.
The Handles of straight razors are made from all sorts of different materials, including wood, rubber, horn, ivory, Bakelite, vegetable ivory, and metal. Inlays and additions can be of mother of pearl, silver, copper, ivory, wood, tortoiseshell.
Looking after your cut throat razor. The straight razor must be properly looked after in order to ensure the maintenance and long life of this traditional men’s accessory. While straight razors made of stainless steel are less demanding, other straight razors have to be rinsed with clear water and thoroughly dried after each use. When not in use for longer periods, it is recommended that the blade of the straight razor be rubbed with light oil. likewise, the razor should not be stored in a damp and unaired state. there is no generally valid rule for the whetting (stropping) of straight razors; in many cases, it is sufficient to draw the razor lightly over the ball of the thumb, especially when it has been left unused for several days between shaves. Wet shavers of the old school know that the facet (blade) “grows”, i.e. the microscopically discernible and extremely fine “fin” on the cutting edge changes during the shave but returns to its old position afterwards; it stretches and again becomes extremely fine. Nevertheless, this fine “fin” will still wear away at some stage and a suitable strop should then be bought.
There is no common rule for sharpening of straight razors; sometimes it is sufficient to sharpen it at the ball of the thumb, especially if the razor is not used for several days. People, who often use razors, know: the cutting edge is growing, meaning that the very fine burr on the cutting edge (which can be seen under the microscope) changes whenever the razor is used, but it finally goes back to its old position and will become very fine again. Nevertheless the burr will wear out after a certain period of time, and then the suitable razor strop should be bought.
How do I whet the razor with the strop? While flat blades are whetted on a suspended strop (velvet knives), 1/2 or 1/1 concave blades require a hanging strop made of fine cowhide leather or extremely supple Russia leather either with a turning device for hanging up or with hemp hose on the back, which serves to align the “fin” in the direction pointing away from the razor. If required, the leather side can be rubbed with an extremely thin layer of fine abrasive paste (red paste) and – for a final polishing on a separate strop – with polishing paste (black paste), which is worked in with the ball of the thumb. Stropping is performed at a flat angle with the back of the razor laid on the strop; the razor is drawn in the direction away from the body.
The razor is then turned over on its back and drawn in towards the body. Changing directions without turning the razor over makes the blade become round (crowned) so that the cutting properties are lost. in this case, only re-sharpening can help.
Straight razors are usually whetted in the factory for use (whetting on leather by hand). If you own a suitable strop, you should nevertheless take into account that the razor must first “rest” after use. After the razor has been carefully rinsed and dried, it should not be used again for at least 24 – 48 hours because the fine “fin” on the cutting edge straightens up again extremely slowly. If the razor is stropped too soon (or stropped incorrectly by moving it backwards and forwards without turning it over), the “fin” which is necessary for a close shave breaks off. Between six and fifteen shaves are possible without stropping in between.
How do I shave with a straight razor? The beginner starts first with the smooth and unproblematic areas of the face. to do this, the open straight razor is held with thumb and three fingers so that the opened holder points away from the face. Lathered with good shaving soap and thus made supple, the skin must be tightened; the straight razor is moved at an angle of approx. 30° firstly in the direction of growth of the beard and then against the direction of growth. If held too flat, the razor rips the stubble; if held too upright, it cuts the skin. Always move it in the direction of the cutting edge and never horizontally (danger of injury); always draw it through evenly and hold it a little more upright at corners, dimples and at the upper lip. If the razor gets damaged by being dropped or when being put into its holder, it should not be used further. Stropping does not help here; the razor must be re-sharpened and whetted by a specialist.
Tips for straight razor users. In general, the best environment in which to store straight razors is well-ventilated, dark, room temperature (72F or 20C), and neither too dry, nor too damp.
o It is advisable to keep straight razors out of water and away from liquids as much as possible — both because water will encourage the iron-based blades to rust, and also because water can cause serious damage to many handle materials. Cleaning straight razors with bleach, ammonia or detergents is discouraged, as these substances can also cause damage.
o The Blade: Metal polishes, such as Brasso, Silvo, or Autosol should never be used on the blade of a straight razor. As well as damaging the surface, they can leave polish residues which are both unattractive, and can be harmful to the blade and handle.
o If the blade is exceptionally dull or nicked, the use of a sharpening stone is recommended. a leather razor strop can be used to maintain a keen edge. You know you’re getting close when you can slice a piece of paper with your razor.
Next, clean the entire surface of the blade with a Q-tip dampened with either ethyl alcohol or rubbing alcohol. this will help degrease the blade of the straight razor. then, apply a thin coat of light mineral oil to the blade; let it sit for a short while (10 minutes, or so), and then wipe the excess oil off using a clean, dry cloth. this oil coating will help prevent any further rusting. If you use your straight razor, use rubbing alcohol to remove the oil before use, and again after use to clean the blade. use mineral oil to re-oil the blade after use, as well as after sharpening. be careful not to get any alcohol or oil on the handle.
Article Source: EzineArticles.com/?expert=Kevin_Nicholls
When guys have a little shadow of hair on their face after shaving, i kno its not done with a razor because that gets to close of a shave, but is it done with a electric razor on a chossen setting or something, shaving with razor is to close for me i like the idea of shaving but leaving like a 5 o clock shadow so whats that done with..?
its done with an electric razor
I shave my facial hair with an electric razor because shaving with a real one (even with four blades) is painful, even with good shaving cream – I think my skin is pretty sensitive or something. however, shaving is also painful with the electric razor, and I have to wait at least two days before I can shave with reasonable comfort again. also, it's not a very thorough way of shaving. Any advice on making shaving (with either tool) a less painful and more thorough experience?